According to statistics, China's tire retreading market will grow by more than 10%. In 2012, the refurbished capacity was 18 million tires, representing a market size of more than 6 billion renminbi ($ 972 million). Most of the refurbishments were done by small scattered workshops or factories; of the nearly 600 companies that could be called "retrofitting plants," only 22 of them had annual production capacity exceeding 100,000 in 2013.
Every year, more than 200 million tires reach their first life in China, and this figure will continue to rise unstoppable over the next few years. However, because of new tire production capacity and other reasons, the development of domestic retreaded tires is very slow . The first is the consumer misunderstanding of the tire retreading industry. Many people think that retreading tires is an unsafe product for small workshops, and this view has been fueled by some Chinese media, such as defaming the industry as "illegal business operations" and "enhancing high pollution," and the negative result is that Many vehicles will not use retreaded tires.
Second, China lacks the necessary regulatory influence and policies to effectively dispose of scrap tires and their recycling. A large number of used tires are burned or discarded, wasteful of reusable raw materials and environmental pollution.
Third, experts from Aeolus Tire said that many Chinese drivers will use or wear out tires until they are scrapped. This approach also greatly reduces the retireability rate.
Due to the above factors, the refurbishment industry in China has developed very slowly in the past decade. China's tire renewal rate is also much lower than that of mature markets such as Europe and the United States.
The OTR segment (referring to the construction vehicle tire market) is an area of ​​potential growth for the Chinese tire retreading industry. According to calculations, it is estimated that the annual demand for construction machinery tires in China has exceeded 5 million, and the market for renovation and gestation should be 600 million yuan.
2 Roll crusher is also called double roll crusher, double roller crusher, double teeth roll crusher etc. The surface of roller crusher are made of high manganese steel, which can stand up to heat treatment. Double roller crusher is suitable for rough and intermediate crushing of brittle materials in such industries as cement, chemical industry, electric power, mine, building materials and metallurgy. The grain size of the input material is large, the particle size of the output product can be controlled, and it is possible to effectively destroy the material whose compressive strength is less than 160 MPa
Double Roller Crusher,Two Roll Crusher,Stone Roller Crusher,Fine Double Roller Crusher
henan ascend machinery , https://www.ascendminingmachinery.com